LaGriT Mesh Generation Demos CFEM 2007

Insert Faults, Subduction Zone, Strike Slip Benchmark, Reverse Fault

Demonstration of the building a simple mesh and use of PSET (point set) command:

demo_pset

Simple example of inserting a fault surface into a 3D mesh that is small and runs quickly:

insert_fault_quick

Simple example of inserting a fault surface into a 3D mesh:

insert_fault

Insert a fault surface with a uniform buffer around the fault so the fault forms a volume instead of a surface:

insert_fault_volume

Insert a fault surface with a wider uniform buffer around the fault so the fault forms a volume instead of a surface:

insert_fault_volume2

Insert three faults into a tet mesh:

insert_multiple_faults

Subduction zone model (2D) with only slab as a seperate material:

subduction_2d_slab_only

Subduction zone model (2D) with only slab as a seperate material:

subduction_2d_triangle

Subduction zone model (3D) low resolution:

subduction_3d_low_resolution

Subduction zone model (3D) medium resolution:

subduction_3d_med_resolution

Subduction zone model (3D) high resolution:

subduction_3d_high_resolution

Same as 'insert_fault_quick' but extra steps are taken to improve the element aspect ratio of the final mesh:

insert_fault_quick_improved_aspect

Strike Slip Benchmark Mesh:

strike_slip_benchmark

Dipping fault inside a large block:

dip_block4_sin_fault

Insert 30 faults from the Community Fault Model (CFM) into a 3D tet mesh:

insert_cfm_1_30